Schedule 24 – General Service – Greater Than 400 Amp Service

Amp Service

Effective for all bills rendered after October 1, 2017

Applicability

To commercial and general service Customers not subject to other specific rate schedules whose service entrance requirements are either single-phase service and exceed 400 amps or three-phase service exceeding 200 amps, and whose peak monthly load is less than 1,875 kW.

Character of Service

Sixty hertz alternating current at such phases and voltage as the PUD may have available.

Monthly Rate

Customer Charge: $50.00

Energy Charge:
For all kWhs – 5.10¢ per kWh

Demand Charge: $6.38 per kW
(30-minute rolling intervals)

Minimum Monthly Charge

The Customer Charge shall be the minimum charge for each meter, except that a higher minimum may be specified in accordance with the PUD’s General Terms, Conditions, Rules, and Regulations for Electric Service.

BPA Power Cost Adjustments

All applicable BPA Power Cost Adjustment charges per Rate Schedule 94 shall apply to all kWhs billed to Customers under this Rate Schedule.

Average Power Factor Charge

In addition to the Energy and Demand Charges, the Customer shall pay an Average Power Factor Charge as determined in Rate Schedule 92.

Metering

Normally, metering will be installed on the secondary voltage side of the transformers. The billed energy will be adjusted by applying a loss factor or the actual cost of losses to the bill, should the service be primary metered for convenience.

Other Charges and Conditions

All other charge and conditions shall be pursuant to the General Terms, Conditions, Rules, and Regulations for Electric Service.